Bipassing a/c with serpentine belt
SOURCE: replace the serpentine belt
First note the route of the belt. make a drawing.
Adjustments are made by moving the power steering pump. far right of belt system.
loosen top fixed bolt above center of drive wheel on p/s pump.
loosen bolt below drive wheel on p/s pump.
Push p/s pump to the left to loosen belt.
Remove old belt .replace following route of your drawing.
move p/s pump to right .
top of belt should have 1/2 inch deflection.
tighten bolts
The end
If you dont have belt route mail me at
[email protected]
for drawing
Good luck .Andy Bartolo
SOURCE: diagram for 1998 Jeep right hand drive serpentine belt
http://www.fixya.com/cars/t2857543-need_diagram_serpentine_belt_replacement here is a link that should help u
SOURCE: i need diagram for serpentine belt installation on 1999 jeep .
Check HERE for few engine sizes:
-
1999
JEEP WRANGLER - L4 2.5L 150ci GAS FI N P
-
1999
JEEP WRANGLER - L6 4.0L 242ci GAS FI N S
Hope this help (remember comment and rated this post).
SOURCE: looking for serpentine belt diagram for a 1998 jeep wrangler
hi i have a picture i can email it to you, my email is
[email protected]
and i will send attachment of picture, it has 3 types, one with no power steering, one with power steering, and one with power steering and a/c hope this will help
SOURCE: I need the diagram for the serpentine belt on a
AllData does not show a 2.7 engine in a Patriot. However they do show a 2.4. Here is the 2.4
belt routing diagram:
455 views
Usually answered in minutes!
×