2003 celica gts speedometer repair

SOURCE: 2001 Toyota Celica GTS Clutch

i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.

SOURCE: 1991 Celica GTS Cruise Control Problem

You may have a faulty brake lamp switch at the brake pedal. If the brake lights come on (via a bad switch), the cruise will cut off.

SOURCE: 2003 Toyota Celica GTs 6-speed transmission problem

Grinding going into third gear only may indicate a worn syncronizer ring. There are no adjustments on the shift cables, so I doubt highly that changing the cables will help you, since you are talking about 3rd gear only. Please note: This issue may be still under warranty, if your vehicle has less than 60,000 miles and is not 5 years old. Replacement of 6-speed internal parts is best left to a pro.

SOURCE: 1985 convertible celica fuse location

Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Greg Bernett

• 2993 Answers
• Posted on Feb 27, 2010

SOURCE: How to instal serpentine belt Toyota celica 2001

Removal & Installation

1. Remove the right hand cover under the engine.
   
2. Turn the drive belt tensioner clockwise to relieve tension on the belt.
   
3. Remove the fan and generator V belt.
   
4. Return the tensioner to the unloaded position.
   
   NOTE When retracting the tensioner, turn it clockwise slowly in 3 sec. or more. Be sure not to apply force rapidly. After the tensioner is retracted all the way, do not apply force any more than necessary.
   
   

1. Turn the drive belt tensioner clockwise
   
2. Install the belt.
   
3. Install the right hand cover under the engine.