2004 Ford Crown Victoria Logo
A
Anonymous Posted on Jun 25, 2014

Is there an access panel to the fuel pump in my 2004 crown vic intercepter?

2 Answers

Brian Karn

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 6 Answers
  • Posted on Jun 29, 2014
Brian Karn
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Dec 07, 2013
Answers
6
Questions
1
Helped
956
Points
13

I don't think so. You may need to drop the gas tank.

gjosephr85

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jun 27, 2014
gjosephr85
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 15, 2012
Answers
1
Questions
1
Helped
251
Points
1

No, there is not. I have found a shortcut though. Of available you can cut the tail pipe that blocks the entrance into the gas tank making it unneccesary to drop the take. You would then have to weld the tail pipe back into place when you're finished. Otherwise you must drop the tank in order to gain access into it.

Ad

1 Related Answer

Anonymous

  • 1 Answer
  • Posted on Nov 14, 2011

SOURCE: where is fuelpump on 2003 crown vic police intercepter

can you replace a fuel pump from a 2000 Crown Victoria with out removing the gas tank

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I change the battery and know all the lights are on on the climate control but nothing works 2004 crown vic.

Yes
1st pull tire from pass rear. 2 tie exhaust to pass side to help clear fuel pump access cover. 3 remove fuel lines loosen passenger tank strap and gain extra wire length . 4 remove access cover 8 mm bolts and work module out of tank. 5 replace pump assembly and 6 replace parts as removed.
0helpful
3answers

Crown vic 2005 no start replaced fuel pump

check your crankshaft position sensor. fuel+spark+compression+timing=ignition.
0helpful
1answer

Im thinking my fuel pump but not sure it only turns over when i prime it once the prime is gone it dies and i dont hear the pump when i climb under tank its a 1999 crown vic w/ intercepter 4.6l also a...

first check the fuse and relay for fuel pump. heres how to check the pump. get under car and put hand on bottom of fuel tank, then have a person turn key to on . if pump is ok. you will feel a vibration in tank. you may have to do this a few times because a fuel pump only runs a few seconds to get fuel pressure to engine then shuts off. but when vehicle is running its on all the time to supply fuel to engine.
1helpful
1answer

2004 crown vic two fuel pumps in thirty days

ouch, have power supply tested for proper voltage to pump,also have ground checked. i believe pump is overheating causing failure, Possible causes, 1) insufficiant voltage 2) bad ground causing power surges 3) Inproper ventalation of fuel tank 4) dry run pump (no fuel) 5) faulty pump relays
I hope this gives some insight but we just don't know untill tests have been made
1helpful
3answers

Does the crown vic police intercepter take as much oil as the regular crown vic? (when changing the oil and filter)

I ~think~ the 1999 is the same as the 2000 (mine is a 2000 P71)

The 2000 CVPI (Crown Vic Police Interceptor) owners manual recommends the following:

Engine Oil - Motorcraft SAE 5W-30 Super Premium Motor Oil 5.0 quarts

Transmission Fluid - Motorcraft Mercon V ATF 13.9 quarts (fluids Mercon & Mercon V are NOT INTERCHANGEABLE, DO NOT MIX)

Fuel Tank - 19.0 gallons

Break Fluid - DOT 3


Rear Axle Lubricant - Motorcraft 80W-90 Premium Rear Axle Lubricant 3.75 pints (add 4 oz of Additive Friction Modifier C8AZ-19B546-A or equilavent meeting Ford Spec. EST-M2C118-A for complete refill of Traction-Lok Rear Axles)

Engine Data - 4.6L V8 Engine
Cubic Inches - 281
Required Fuel - 87 Octane
Firing Order - 1-3-7-2-6-5-4-8
Spark Plug Gap - 1.3-1.4 mm (0.052-0.056 inch)
Ignition System - Coil On Plug
Compression Ratio - 10.0:1

I hope this helps!
1helpful
1answer

Crown vic police interceptor 2004 has difficulty starting after sitting all night

the fuel pump is defective, there is a Ford service bulletin on this problem, there is a new pump available.
3helpful
2answers

Location of fuel pump relay on a 2001 Ford Crown Vic

where is the fuel pump relay on a 2001 crown vic p71
Not finding what you are looking for?

261 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...