2003 Dodge Grand Caravan AWD Logo

Related Topics:

A
Anonymous Posted on Jun 25, 2014

Removing inside door panel

03 grand caravan

5 Related Answers

Anonymous

  • 19 Answers
  • Posted on Jan 15, 2009

SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport

1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery


Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.

Ad

Anonymous

  • 316 Answers
  • Posted on Apr 24, 2009

SOURCE: how to remove interior door panel on a 1997 caravan with ower windowq

Start by removing the negative battery cable from the battery. Then locate and remove the screws that hold the interior door handles in place (they may be hidden by snap in, or snap on covers). Once you have removed the interior door handles, disconnect the wire clips that go to your window and door lock controls.
I personally use a small pry bar to remove the interior door panel; it is held in by plastic snap clips. Try to get as close to, or directly under the snap clips as possible with your pry bar to prevent them from tearing out of the door panel. Once you have released the snap clips, pull the panel upward to remove it. Install in reverse.

I hope this information helps you, and I wish you luck on your repair.

Jason Johnson

  • 1619 Answers
  • Posted on Jul 31, 2009

SOURCE: Conflicting procedure for removing 2002 Grand Caravan door trim

Chiltons is a very basic manual cover numerous years. To check slighty pry the bottom edge of your door with your fingernails if it is tight all the way to the bottom it probably is the snap fastners. Make sure to remove the door handle bolts/nuts.

Efstathios Govas

  • 285 Answers
  • Posted on Sep 05, 2009

SOURCE: removing/installing 2000 dodge grand caravan window glass

after u remove the bolts that hold it to the window regulator tip the window towards the front of the door and the top rear corner of the window should pop out and then u just lift hte window out,hope this helps

Testimonial: "Thank you!"

Anonymous

  • 318 Answers
  • Posted on Nov 29, 2010

SOURCE: How to remove and replace

These are generally not for the do it yourselfer since they are spot welded in place and there are many sizes of panels to fit the area you need to replace. Have an auto body shop look at it for advice - many give free estimates.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
0helpful
1answer

Removal of rear door lift hatch interior plastic panel on a 2005 Dodge Grand Caravan to push out dent in metal door from the inside.

The rear door panel is secured to the door using screws and clips. The screws will be in the handle used to close the door and there may be plastic plugs in the handle hiding the screws. Once these screws are removed, the handle will come off. Look for any more screws along the panel. If there are more, they will be visible. Once the screws are removed, pull on the panel to release the clips that secure it to the door. These clips will require some force to release them and will make a snap/pop sound once released. You may have to put a screwdriver/wedge between the panel and door to start the process of releasing the clips
0helpful
1answer

How to remove a interior plastic door panel from a 2005 Dodge Grand Caravan lift hatch

2 screws in arm rest 1 on the both side 3 on the bottom 1 in the door handle lift up if power windows watch for wires
0helpful
1answer

Why wont my back hatch unlock in the back of my 98 grand caravan

REPLACE THE REAR DOOR ACTUATOR, THAT IS THE MOTOR THAT UNLOCKS THE DOOR FOR THE HANDLE TO WORK, THE KEY DOESN'T MOVE THE LOCK TO OPEN THE DOOR, REMOVE REAR DOOR PANEL TO ACCESS IT, ROUND HOLE WITH COVER FROM INSIDE CAR WILL ACCESS EMERGENCY KEY WAY WITH SCREWDRIVER CAN OPEN DOOR FROM INSIDE, GOOD LUCK!!
0helpful
1answer

How do i take off the inside drivers door panel on a 2005 dodge caravan

Hi Roberta, here's the instructions on how to remove your door panel. I have to wonder though on why you are removing it, my guess is you window doesn't roll up or down and your replacing the regulator. Any way here goes.

REMOVAL

  1. Remove the plug and remove screw attaching door pull cup to inner door panel.
  2. Remove switch bezel and disconnect power window/memory switch.
  3. Remove screws attaching trim panel to door from below map pocket.
  4. If equipped, remove window crank. (Refer to 23 - BODY/DOOR - FRONT/WINDOW CRANK - REMOVAL)
  5. Remove screw holding door trim to door panel from behind inside latch release handle .
  6. Disengage clips attaching door trim to door frame around perimeter of panel.
  7. Lift trim panel upward to disengage flange from inner belt molding at top of door.
  8. Tilt top of trim panel away from door to gain access to latch linkage.
  9. Disengage clip attaching linkage rod to inside latch release handle (INSIDE DOOR HANDLE LINKAGE).
  10. Separate linkage rod from latch handle.
  11. Disconnect the power door switch, courtesy lamp electrical connectors.
  12. Remove front door trim panel from vehicle.
Hope this helps and have an awesome day Roberta!
0helpful
1answer

WHERE IS LOCATED BLOWER MOTOR IN DODGE GRAND

the blower motor is located in behind the glove box. lower the glove box door and look inside. to remove the blower motor you will have to remove the glove box door and the lower half or the instrument panel to gain access to the heating/air conditioning unit.
8helpful
1answer

How do I remove the passenger side power mirror on 98 caravan?

If you're lucky, on the inside of the door, will be a triangular panel right behind the mirror that you can pop off. If you're not as lucky and it's one piece or the panel is blocked by the door panel, you'll need to remove the door panel to change it.

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can remove the bolts holding the mirror onto the door
0helpful
2answers

I have a 2007 dodge grand caravan. I am replacing

the plug is inside of the mirror housing once you take the old mirror out if you need to plug it after the housing and you replaced the whole mirror the plug is inside the door panel
4helpful
1answer

2005 Dodge Grand Carvan / Removing sliding door panel

www.google.com/search?q=2005+dodge+grand+caravan+remove+sliding+door+panel&rlz=1C1CHBF_enUS982US982&oq=2005+Dodge+Grand+Carvan+%2F+Removing+sliding+door+panel&aqs=chrome.1.69i57j0i22i30j0i390l3.7953j0j7&sourceid=chrome&ie=UTF-8#fpstate=ive&vld=cid:945b513e,vid:_iarDzBb5Yo ---------https://www.youtube.com/watch?v=AAtcsrfy3JY
0helpful
1answer

2005 grand caravan

I am going to bet it's a fuse, broken wire, or a setting in the command module (in my 03 Jeep Cherokees, the command module is in the overhead console.).

If it is a light bulb, then you should be able to pop the switch module up and out of the door panel, then find the bulb embedded inside.
Not finding what you are looking for?

90 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...