Factory stereo removed
SOURCE: how do you get the key ignition out of a 2000 ford focus?
there should be a button on the bottom of the column to release the key from the ignition ad put the ignition in the lock position
SOURCE: how to factory wire fog lights on a 2000 ford
This is a common problem on 97-00 MY trucks, regardless of the trim level ( XL, XLT, Lariat ).
If you install the fog lamp fuse in the BJB ( aka Battery Junction Box, Engine Compartment fuse panel ) Fuse # 9 ( 15 A fuse ) and jumper the normally open contacts in the fog lamp relay socket ( see diagram below ) the fog lamps should illuminate ( to confirm what you have doing on ).
The problem usually is the main headlamp switch to the BJB is not in place ( this is the yellow wire from the main headlamp switch connector to the relay socket pin #1 ).
One easy route is to make an aux lighting relay & harness, or purchase one online. With this, you can cut the factory ends and attach them to the harness you purchased. There is an air inlet next to where the steering wheel column runs through the firewall. This would give you an easy route to the fog lamp switch. The fog lamp switch, you can buy the factory one, and change the yellow wire from the connector to your added relay, or just add a switch for this function.
This will give you an idea of what the DIY relay and harness would look like.
Hope this helps, more than confuses at this point
SOURCE: I need the wiring diagram for the factory stereo 2004 ford taurus
go to the dealer ,parts dept and ask nicely and they will print out the parts page for that area
SOURCE: Can a bad ignition switch drain battery and
An ignition switch probably isn't the problem, because the vehicle probably wouldn't shut off if the switch were the problem. When you turn your car off the battery is not being drained any longer from the switch unless the vehicle is unable to shut down.
The other possibility that will definately cause a battery to lose juice while not running is a faulty starter sellinoid. When these sellinoid's, (may not be spelled correctly, sorry about that) are bad, the motor is turned off but the battery is still drawing current, but the engine is not running to allow the battery to recharge.
It could also be a bad battery. Check your battery cylinders by removing the plastic covering and checking the water level in the cells. Dry cells in a battery will not allow a jump.
SOURCE: 2004 ford escape wiring diagram
This is for 2005 Escape, its possible that can helpfull... LINK
Hope this help.
57 views
Usually answered in minutes!
×