Ingition Switch problem

No, you don't have to take the wheel off. Just have to take the cover off between the wheel and the dash. Once that's off, then you will have access to the ignition. The only thing is, when you get your new ignition in, you will have to take it to a Honda dealer and have the ignition and key coded together. It will save you some money to put it in yourself, but you will have to tow it wherever the closest dealer is for you.

turn ingition on and check if power to the distributor. Check your igniter that may be the cause.

You may have bent the tumblers. A locksmith may be able to fix it.

That has to be done with the special scanner called a Tech2 at the dealer, the scanner allows for an interface to be established with the security module for reprogramming, so sorry you can't do this at home.

There was an ingition recall on 99 accords call your local honda dealer and give vin number couldnt hurt

the problem is in the contacts of the ignition switch on the back of the igntion key cylinder, replace it.

remove the steering wheel and turn signal switch and you will see a torx or allen head screw where the switch is located remove it and wsitch comes out!! if ya lost the key go to a lock smith and he should be able to cut a key from your vin dealer can usually do this also that is if ya lost ur key

the neutal safetyswitch has to be adjusted

If your engine turns over but won't start it could be the igniter that is bad

i went to a better web site. and it was free and worked