Headlight replacement Replace headlight bulb

SOURCE: 2002 Audi TT

Nothing special at all - just remove the back cover on the headlamp and you'll see inside that the bulbs are pinned in place with hinged metal wire clips. Release the clips and the bulbs should come right out.

Jamie Heppner

• 111 Answers
• Posted on Dec 16, 2008

SOURCE: bulb replacment

The bulbs are changed from the rear. There might be a weather cover, once its removed you will see a ring or clip holding in the bulb , remove that to remove the bulb. Install in reverse order. And a little known fact most parts stores will install bulbs for free when you buy them.

SOURCE: replace bulb

Depending what side you need to change? Ive changed loads of these for my customers over the years, Golf's and A3's can both be a little tricky. Directly behind the lamp assembly you should see a large single piece plastic cover. x2 tags are visible at the top and have to be depressed for the cover to tilt backwards and upwards to lift out. Be aware, these tags can break so pushing the cover inwards slightly whilst depressing these tags will lesson the chance of breaking. The dip beam bulb is normally a type 499 and will have a 2 wire connector plug. Pull this straight back to remove. A sprung steel clip holds the bulb in place. With a torch you will see an obvious end to this clip. Depress and ease to the side to bring it out of line with its recess. It will no swing backwards and allow the bulb to be removed. Note the tag is upper most on the bulb. Dont touch the glass of the bulb with your fingers, hold it by the base, then reassemble in the reverse order. Hope this helps? Good luck

SOURCE: 2000 Audi a4 headlight bulb replacement

The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.

The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.

Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.

SOURCE: headlight washer pump

hi all you have to do is remove the pasanger wheel then remove the cover under wheelarch then undo bolt at bottom ov washer bottel then pump will just pull out