Po340 and jerky motion 09 hhr

The check engine light is on ? what code is stored ?

Hi Christine,here's a link on replacing your cam shaft position sensor. 3 DAY FLASH SALE Get 25 Gift Card For Every 100 Spent On Online Ship To...

Po340 is a cam shaft sensor and po462 is low voltage on your fuel guage. So i assume you are haveing fuel level issues. If you can turn wrenches you can do these repairs yourself. Just do a google search and you can get some youtube videos of sensor replacement and location. Have fun.

DTC code is P0340 no cam signal at PCM. Chrysler always used to say replace the cam and crank sensors together..wouldn't pay our warranty time at dealer unless we replaced both.

the po340 code should be cam pos sensor that's whats causing the stahling need to get cam sensor

that is the code for cam position. . when you replaces the sensor did you clean the cam,and replace the seal. what motor do you have

you can do 1of two things 1pull the cam sensor out and clean it up and reinstall it to see if that works or you can replace it with a New one, this is what the code po340 means that you have a problem with the cam sensor

Wiring problem or the ECU (engine control unit) is defective. Try this, disconnect the battery cables from the battery and short/touch them together for 30 seconds (do not do this if connected to the battery). Then, reconnect the cables to the battery posts & see if that fixes it. If it doesn't, then there is a wiring problem associated with the cam pos snsr or the ECU has gone bad.

PO340 IS NO CAMSHAFT POSITION SENSOR CIRCUIT FAILURE.YOUR CAR IS GOING TO HAVE BE REPROGRAMMED BEFORE PCM WILL RECOGNIZE THE NEW CAMSHAFT SENSOR.

My Nissan micro 2004 model just stopped in the middle of the road one day then the engine management light came on, anyway took it to my local garage TWK Thomas who said it was a cam shaft sensor problem. OK so sensor was put on, engine management light went off for two days only. So went back to the garage they said that another sensor should be fitted on the opposite side. And then the problem should be rectified, but i had given the £160 for this problem to be fixed the first time. I decided it was time to take it to another garage Nis Tec they put it on the computer and a code po340 came up would this mean another sensor or the cam chain has stretched please help. ...claire