SOURCE: how to replace rear brake pads on 2005 jeep liberty
put the back of car on jack stands and secure the front tires so it does not roll and then remove the bolts off the back of the caliper there is normally two one at top and one at bottom and spray it with some kind of oil for rust and make sure you have the right size socket before you try to loosen them and once caliper is off and the old pads removed take one of the old pads and squeeze the piston on the caliper back in by using a "C" clamp and also remove some of the brake fluid from the master cylinder before you do this put the new ones back on and check the brake fluid and make sure it is full and then pump the brakes to make sure you have a good pedal also put some "No Squeak" brake stop on the back of the pads so they don't squeak they will have that where you buy the pads from
SOURCE: How to replace reak brake rotors on Jeep Liberty
Replace rear rotors on 04 liberty.
Remove tire & wheel
Remove brake caliper, tie up out of way.
Back off e-brake shoe adjustment.
Remove factory spring clip from lugs (2places)
This is the crude part....
After attempting to pull off disc/drum with puller....I got pretty sick of it. Understand this is in the Northeast with lots of salt on the roads in winter. Needless to say there is a ridge of rust around the inside edge of the e-brake surface. Any more pressure and I was afraid of damage to the e-brake shoe asembly. I then took a small grinder with a cut off wheel and cut the disc thru (used space where caliper usually sits). Also cut nearly through the face between 2 lugs. You can't quite get thru the back corner at the disc. Since the material is cast iron it will crack when you drive a wedge in the slot cut in the disc. This opens the housing around the shoes and it slides off easily. The cutting operation took less than10 mins, alot less than the puller with hammer assist!
I know this is a bit "unorthodox" to say the least, however the object is to remove the old junk disc safely and as quickly as possible, without harming the e-brake parts inside.
Install new parts in reverse order, new pads go in easy after squeezing the caliper piston back with a c clamp as is the normal procedure.
SOURCE: 1999 Jeep Cherokee rear window washer
There are two separate washer pumps underneith the washer res. behind the front driver quarter panel. The exact pumps are hard to find. I have the same prob with my 99, but both are out. I had a 98 that the front worked but not rear. I had to get a "universal" washer pump. I'm still trying to find a factory replacement for this one before I do that. No luck so far.
SOURCE: I have a 2008 Jeep Liberty sport it has 39600 back-up lights not
If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch
Testimonial: "Thank you for the info on my jeep. I brought it to my mechanic and he could not find where the new switch goes.I will bring it to the dealer."
SOURCE: Fuse for brake light on 2007 Jeep Liberty
I dont have owners manuel and need to know what fuse is my brake lights ? All brakes lights are out . Thank you
143 views
Usually answered in minutes!
×