SOURCE: I have a 1995 mitsubishi
if you haven't checked the ASD relay, make sure its working.
if thats okay, check the Cam Angle and Crank Angle sensors. if it isn't any of those, its probably the ECU
SOURCE: crankshaft position sensor location
if u pull the battery and battery tray u can easily reach this
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
SOURCE: brake light bulb Mitsubishi Eclipse Cars
look for access panels in rear hatch there will be one on each side remove those and there will be 10 ml nuts holding the light housings on remove those then you can access the lights
SOURCE: need the vacuum hose diagram for a 1998 mitsubishi eclipse
http://www.dsmtuners.com/forums/attachments/420a-bolt-tech/89827d1228187918-resolved-need-vacuum-line-help-fast-420aturbovac-boostlinesstock.jpg
hope this helps
81 views
Usually answered in minutes!
×