Question about 2007 Ford Focus (3 Door) Hatchback
I have a haynes repair manual that gives directions on how to change the thermostat
Posted on Jun 15, 2014
Follow the upper radiator hose to where it attaches to a housing (2bolts hold the housing in place) remove the hose clamp here and then remove the housing bolts, inside the housing is your thermostat. Clean off the surface of the housing, and where it attaches to the engine. Install the thermostat, and a new gasket (or O -ring ), carefully replace the housing, being sure the thermostat doesn't slip out of position, tighten the housing bolts, reattach the radiator hose to the housing, add coolant to proper level, check for leaks, u r good to go! Make sure the thermostat is installed in the right direction, if put in backwards the car will overheat. countrycurt0
Posted on Oct 14, 2008
you did not state which engine you have but if you are not real handy and/or have experience this is not one you should tackle as your first alternator because...
all will require that you either drop the rear of the subframe or rotate the engine forward to remove the alternator.
everything else is the same...remove the belt, unbolt and remove
about an hour job with experience and two hours if a first time
Posted on Apr 03, 2010
Follow the upper radiator hose from radiator to the engine where it connects to the engine thermostat will sit under that housing held on by two small bolt's.Hope this was very helpful,good luck.
Posted on May 13, 2010
Tips for a great answer:
Mar 26, 2016 | 2007 Ford Focus 2.0
Feb 28, 2014 | 2007 Ford Focus 2.0
Nov 12, 2013 | 2003 Ford Focus
Mar 28, 2011 | 2006 Ford Focus
Jan 25, 2011 | Ford Focus Cars & Trucks
Jan 06, 2011 | 2007 Ford Focus (3 Door) Hatchback
Jun 07, 2010 | 2007 Ford Focus (3 Door) Hatchback
May 13, 2010 | 2000 Ford Focus
Apr 03, 2010 | 2007 Ford Focus (3 Door) Hatchback
Oct 15, 2009 | 2000 Ford Focus
339 people viewed this question
Usually answered in minutes!