What dos the code 1041 for 2007 getta 2.5 means?

Check for blown fuse

Variable Valve Timing System Malfunction, and possible causes - dirty or low engine oil
- Valve timing
- Oil control valve
- Variable Valve Timing controller assembly
- Engine Control Module (ECM)

Read more: http://engine-codes.com/p1349_toyota.html#ixzz38fIMYdTd

Here is what i found on the inteenet concerning your codes!!


P0303 Cylinder 3 Misfire Detected

P0336 Crankshaft Position Sensor A Circuit Range/Performance
P1870Transaxle Component Slipping

Third one is affected by the 2 other don't look for it . for sure you are going to have problems with your tranny if your engine doesn't go as it's supposed.

to look for 2 others go to that site http://www.obd-codes.com/trouble_codes/. you'll find out what you need.

getta haynes manual or go to part store

getta scan done--may hav some wiring issues too--sensors-or injector driver in computer cud be bad----its almost 20yrs

thats the default mode--meaning the vacuum hoses or switch has issues--u need to take the dash down to inspect--getta haynesor othr manual for dtails

getta data stream run-code readin is not accurate--an independent shop does it--u want values and numbers--also do a tuneup on ignition and fuel areas--haynes manual shows how

if starter doesn't engage, replace the starter.

oxygen sensor bank 1 sensor 2.
I would just have some one who has a hand held computer to erase the code then drive the car a few days to see if it come back on.
before you replace the sensor, you need to check to see if you need any spark plugs, filters. check for vacuum leaks, ect.

4 cyl 1 3 4 2