I jump start my 2005 ascender the radio was working fine before i jump started it but its turning on i think maybe its fuse blown. I am trying to locate the fuse for the radio
SOURCE: after an oil change my
wow i dont know where to start... when was the fuel pump replaced, had you ran it sense?? because the newer vehicles need to teach themselves how to idle, shift and everything all over again if you take the battery cable off. as far as not starting are you sure that the fuel pump is running?? and what was the sensor you replaced?? if i had a little more info i could help you a little better
SOURCE: Brake Lights
it could be your brake light switch. it is located underneath the steering column, where you step on your brakes. it is bolted on a nut and being pressed upward by the brake pedal if your not stepping unto it. once you step on the pedal, it would be released and make contact to light up your brake light.
tnx 4 using fixya.
drcool
SOURCE: which fuze do i replace on a 2005 isuzu ascender
i assume that you have a trailer light attachment installed at the rear of the vehicle somewhere around the tow hitch,turn on your head lights,obtain a volt meter and check D.C. voltage on the pigtail,ground the black lead to clean frame metal and check the pins on the plug with the red lead,one of them should be live 12v dc.that will be your trailer running lights,theother will be brake lights,you will have to have someone hold trheir foot on the brake to test it,dont assume the trailer is ok. verify voltage at the connector on the vehicle first,if you have 12 v,there the trailer has the problem,or if it hasnt been used in a long time the connector may need to be cleaned,as far as the fuse goes depending how it was installed,could be several choices,set your meter on continuity and check all fuses,you dont have to phisically remove each one,if you look close there are two small contact points on both sides of the amp rating number,most likely you will have two or three fuse panel locations,primary is under dash drivers side ,secondary panels and relays located in engine compartment under hood on fender walls black plastic box w/cover,,also may be on the sides of the dash board,can only see when the door is open ,or behind the ashtray in the center console,replace any fuses that are blown,be aware of the plug configuration on the car to the trailer,and that the ground wire on the car side of the plug is also the ground lead on the trailer connector, wires may have got mixed up during repair,happens to the best of us once in a while,clean ground connections are very important on trailers,old rusty wires and scerws should be removed wire brushed and reinstalled,or replaced if needed,then sealed with varnaloc,or spray paint,to protect them,hope this helps you.aloha from maui todd0708
SOURCE: My brother in-law tried to jump start our ascender
didnt notice any or didnt find any, check ALL the fuses, if all are OK, then have a shop look at it, explain what happened, then senf him the bill. ; )
571 views
Usually answered in minutes!
×