1998 buick skylark engine wont turn when you turn key power good

Brake Hydraulic System Red Warning Light - RepairPal

repairpal.com/brake-hydraulic-system-red-warning-light
If the red brake light blinks, or comes on and off intermittently, and there is no change in the feel of the brake pedal, then have the vehicle properly diagnosed by ...

Ignition Key Stuck Due to Failed Shifter : Buick Skylark ...

repairpal.com > Problems > Buick > Skylark
Key Stuck in Ignition Lock Cylinder on Buick Skylark ... wires on brake look good same with wires on shifter,key is froozen moves but not out of locking ... when key is turned all lights come on and accessories work but engine does not turn over ...

which engine?

check fusible link also check for power at starter first..make sure trigger wire is good at starter

Your PassKey Security System is malfunctioning. The most likely cause is a bad ignition lock cylinder. Try this to get it started:
1. Set the parking brake. (This will keep your headlamps from coming on and running your battery down)
2. Turn the key to the "START" position and release it to the "RUN" position. (Do not turn the key to the "OFF" position or you will have to start over.)
3. Leave the key in the RUN position for about 10 minutes until the SECURITY light stops flashing.
4. When the light stops flashing, turn the key to the "START" position again.


This should get the engine started so you can drive the vehicle to get it repaired.

Have your starter checked,also make sure you are getting battery voltage and Ignition voltage to your starter solenoid.

sound like powertrain control module is not powering up everytime

starter

Are you getting fire to the plugs?

Are you getting fuel?

"Won't start" doesn't tell me anything.

I think he may have just bent the connection that activates the horn. Does it honk when you turn the wheel one way or the other? Try that and let me know what the out come is.

Very Good Guess