SOURCE: where is the crank position sensor located in 2005
Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: Where is the input speed sensor on KIA sedona 2005
on transmission has 2 wires at right side of trans .by axel
SOURCE: Crankshaft position sensor replacement on 2005 Kia Sedona
The CPS is located under the timming cover 4 small bolts remove the cover and the sensor is viewable 2 bolts have to be loosend and the wire leads up to a dual connector on the left side of the engine
SOURCE: where is the crankshaft position/crank
Hi, at the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump
The crankshaft position sensor is mounted on the engine near the crankshaft.
Operation
The crankshaft position sensor is a Hall-Effect sensor that senses the crank angle (piston position) of each cylinder and converts it into a pulse signal. The signal from the sensor is relayed to the ECM to indicate engine rpm and the position of the crankshaft.
Removal & Installation
Temperature - 4°F, test specification 1500-1700 RPM Temperature 32°F, test specification 1350-1550 RPM Temperature 68°F, test specification 1200-1400 RPMTemperature 104°F, test specification 1000-1200 RPM Temperature 176°F, test specification 650-850 RPM
635 views
Usually answered in minutes!
×