How do I reset perform service indicator on my 2007 Ram 2500 6.7 diesel after all service has been done
SOURCE: I have a 2006 Dodge ram 2500 diesel I can not get
First I thought it was the fuse panel or the power module but with our newer truck the computer told the power module not to send power to my A/C compressor b/c the A/C Clutch was out, (you can't replace just the clutch so I just had to replace the compressor and not the power module b/c the truck's computer told it not to send power this is the same with anything that goes wrong with the truck the computer tells it not to send the correct power to the part that is broken thus it seeming like the part isn't getting power, The power Module (fuse panel) is just doing its job replace whatever went out first or is bad, and the power will naturally be restored or you can go to your dealer and have the Power Module Flashed as they call it which resets it.
Jason
SOURCE: reset the engine control light in a 2007 dodge ram
If you cycled the key, and came up with only -------- done then you have no stored/active codes. There is no need to reset the computer, but if you still want to, you can disconnect the battery and touch the positive and negative cables together for 10 seconds. this will discharge the pcm's capacitors, ON A DIESEL BE SURE TO DISCONNECT BOTH BATTERIES!
SOURCE: Perform Service light reset
1.Turn key on/eng off
2.Press brake pedal slowly 2 times
3.Press gas pedal 2 times within 10secs.
4.Turn key off
SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
SOURCE: I have a 2006 Dodge Ram 2500 Diesel (no owners
I don't have a owners maual either but I beleive its 10 liters.Use 15w40 ams oil with ams oil filter.7500-10000 miles for filter changes and 20000 miles between oil changes
122 views
Usually answered in minutes!
×