SOURCE: how to remove a starter on 1993 chevy lumina?
Support the car very securely first of all
Remove the negative cable from the battery
Remove the wires from the starter
Remove the two bolts from the starter going upward to the engine block
Wiggle the starter out
Reverse this proceedure to reinstall
SOURCE: I have a 1993 chevy
try not tobecome a parts replacer-buy a haynes manual instead--I believe the throttle body is filthy or an idle air valve is-there r solvents to clean this
SOURCE: i have a 1993 chevy
check for injection pulses at the injectors.
Each injector has two wires, one is a supply (12Volt) and the other is grounded by the engine management unit. The switching is very fast so you would not detect it with a test light. Try a multimeter set to frequency. If you check the supply to the injectors, disconnect ALL of them at once. You should have power to only one wire at each injector plug. If no power is present, check the fuel system relays and fuses.
SOURCE: 1993 chevy lumina-tps
"TPS" stands for Throttle Position Sensor. It is located in the same place that all TPS sensors are located - on the throttle body.
52 views
Usually answered in minutes!
×