SOURCE: 1998 jeep grand cherokee
Under the glove box beneath the dash the resistor should be screwed into the heater housing.
SOURCE: Where is the Powertrain Control Module located on
It should be under the dash or on the midle console,
SOURCE: 2004 Jeep Grand Cherokee. Keeps stalling, engine
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
SOURCE: WG Jeep Grand Cherokee Limited workshop service manual.
see if advanced auto, or autozone carrys it
SOURCE: Where is the ABS module located on a 2004 Jeep
Hi,
The ABS module is located on the drivers side inner wheel well (under the hood) and mounted vertically. The black electrical connector has a silver clasp on it you have lift the silver clasp and pull the connector off the module.
Thank you !!
157 views
Usually answered in minutes!
×