9 hrs on a 4wd 7 on a 2wd. That is chilton/mitchell time. a good tech will beat that time but deserves to be paid accordingly
SOURCE: Rear Axle Seal Replacement
remove rear tires, then remove brake calipers and rotors, then remove the 4 nuts (each side) that hold the axle shafts to the axle tube (located around the axle tube behind the backing plate) then using a slide hammer pull the axle shafts out, next using a die grinder and an air hammer get he retainer collar and the bearing off (without damaging the axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then retainer on (all new parts) and using a press push them all the way back on. then is simple reassembly.
SOURCE: Rear Axel Seal Leaking, How do I pull the axel to repair?
You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.
SOURCE: 1994 jeep cherokee workshop manual free download required
onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/chrysler/1993-chrysler-zj-jeep-grand-cherokee-grand-wagoneer-service-manual-and-supplements-pdf.html
just go the above link i think u can get one online for free
please rate my answer
SOURCE: rear main seal replacement for
Wrong. just remove the oil pan, exhaust downpipe and O2 sensor, and starter. take off the crank bearing brace and finally remove the rear main bearing cap. half the seal will be in the cap and half you push out from around the crank with a small brass punch so as not to damage the crank pull out with needle nose pliers and slide the new one in ( noting that oil should go on the mating surface of the crank and liquid dish soap on the outside of the upper seal). rtv the lower seals wings (top and bottom) and reinstall. rear main cap 80ft.lbs i believe, 35ft.lbs for the bearing brace. or just follow this tutorial with pics http://dailydriventj.com/forum/viewtopic.php?t=811
SOURCE: speakers for 1994 jeep grand cherokee
6.5" in all the doors dash is wierd. 2.75" but i have been able to squeez in a 3.5"
Testimonial: "thank you so much, that helps me out as lot"
66 views
Usually answered in minutes!
×