Were do the cluch fluid goes - 1996 Mazda Protege

no cluch fluid

is this a fluid cluch or a cable unit..repost

The clutch master cylinder reservoir is on the firewall under hood near the brake master cylinder. It has a round black screw on cap as I recall. Use Dot 3 or 4 brake fluid.

If it lost power while shifting, and didnt engage, or lost power while accelerating, it is probably your pressure plate.

These jeeps have an hydraulic system with a master cylinder up top and a hydraulic line leading down to a slave cylinder. You likely have a leak somewhere and your hydraulic fluid is gone.

The manual transmission cluch is powered by the power brake system and share fluid. Check your brake fluid level to see if it is low. If it is low, you have your culprit! Just add more fluid to the brakes and you should be fine. If you think you might have a leak, have it checked. Brake fluid is flamible and an overheated cluch could cause it to catch fire.

if you have a leak in the cluch fluid is it the master cylinder or the slave cylinder leaking??? you may be ably to get a repair kit for it or replace the hole unit then bleed it through

check fluid level if low bleed out the system.If thats fine then you have slave cylinder Problem.Before Changing the cluch assembly check your master cylinder is pushing good pressure.

the trasmission fluid leval may be low or your cluches are slipping. check the trasmission fluid leval with the engan wormed up and the trasmition in park pull the dip stike with yellow on it and check the level alsow smell the dip stick if it smells burnt the the tran fluid need to be changed.
if it is low put tranmition fluid in it by using a long funal and put the fluid in the tranmition dip stike tube. If the leval is full and the fulid is not burnt it might be trasnmiton cluches and the tranmition needs to be rebilt.

you drain the trans fluid with drain plug on bottom of transmission