Why does my town and country start run for a few seconds then die. It will not stay running even when giving it gas.
SOURCE: Engine light stays on 2005 Chrylser Town/Country
If the Check Engine light is on, your vehicle will should have fault codes stored in the computer. Have a service tech perform a diagnostics test on your vehicle to extract the codes. This will give you an idea of the problem. My guess... O2 sensor since your vehicle is running fine. Codes will be necessary to verify.
SOURCE: my 2005 town and country stalls after fillup..any ideas?
every vehicle should have one. trace your fuel line. could also be some water in your gas tank. put in some isopropol alcohol / gas line antifreeze to dissapate water.
SOURCE: 2006 Chrysler Town and Country key needs reprograming
Keylessride.com my be a little cheaper
SOURCE: AFTER CHANGING MAP SENSOR FOR MY 2001 CHRYSLER
try reseting the immobiliser/alarm or fitting new bateries to the remotes then reseting as a first step.(i am assuming you disconnected the battery to fit map sensor)
SOURCE: 97 chrysler town & country
Well first it should only restart in park or nuetral, any check engine light on? May be fuel pump if not. Listen for pump running in fuel tank. Should run at key on for a few seconds. If check engine light on, it should be scanned for codes, possible crank sensor
230 views
Usually answered in minutes!
×