Where is located the knock sensor and how replace
Old posts.
asked vast times
here again.
J20b engine, is 4 banger,
the knock sensors on most 4 bangers are on the center of the block between #2 and #3 water jackets, (best sonic location)
now ill post a photo of this. btw the 4 buck service manual covers this>?? a fact.
you ask how to unscrew a sensor? really?
why not look first and see it.
the sensor, if you bought one, is a donut shape with center hold down screw, we just unscrew it. 6mm bolt. i think it is.
its on the starter side, see ST?
and is there,
aka, as the fire wall side of the engine.
its in the best spot too, sonic-ally, best.
jacking up car on stands does wonders to find things here.
SOURCE: location of cam position senor
Not a bad job to replace the cam position sensor, it took about two hours cost about $150.00 with oem parts. First remove air filter box,remove plastic spark plug cover. Jack up engine about an inch remove engine mount. Now you can access sensor through a convenient cover that mounts around engine mount bracket extending from engine block.( one ten millimeter bolt) Remove accessory drive belt for a little extra room and replace with new one while you are in there. Just between the two cam gears you will see a torx screw that aligns the switch when in installed. DO NOT REMOVE THIS Just above the torx screw is a reverse torx screw (6 millimeter) Put a shop rag in the access hole to catch the screw just in case you drop it ,( so it does not fall into timing belt cover) Put something "sticky" in the 6 millimeter socket such as gasket sealer to keep from losing screw. remove. Pull switch up from inside spark plug cover and install new one through the same. reinstall 6 millimeter bolt. Switch is self aligning. Reinstall belt, engine mount, air box. Doing this myself probably saved me about $150.00 to $200.00 dollars
SOURCE: Tire pressure sensor 2007 suzuki forenza
check ALL tire inflation if its within the specified range. your computer wont reset if one is low or above the manufacturers specifications.
SOURCE: on my 2007 suzuki forenza the check engine light
no such code on that car, auto zone uses global testing which pulls universal codes, so that code means someting different for the suzuki, need to have it checked by the dealer or a shop that has import software, or post the code # and i can translate it into import code, good luck.
SOURCE: Where is the transmission range sensor for 2006
Right on the transmission, to the right side of the engine bay as you are looking down on it. It is a black plastic part that is bolted on the transmission with two 10mm bolts, and connected to the transmission with rod and clip. It is partially obstructed by the radiator hose, but otherwise really easy to get to.
SOURCE: how much isa transmission range sensor for a 2007
Make sure to check for an adjustment,if there is one,before replacing it.
237 views
Usually answered in minutes!
×