-
Master
1,800 Answers
- Posted on Jun 25, 2009
Re: Driverside window wont go up! motor works but seem...
Hello Sir.
Welcme To Fixya's Community.
- Remove the rear door trim panel, as outlined in this section.
- Remove the plastic sheet water deflector.
- Remove the window-to regulator bolts by raising the window far enough to gain access to the bolts through the door metal.
- Raise and securely tape the window in the full up position.
- Detach the electrical connector.
- Remove the mounting bolts and remove the regulator from the door.
- If the motor is to be replaced, simply unbolt the motor from the regulator.
To install
- If the motor is to be replaced, install the motor to the regulator. The motor can be installed with the regulator in any position. Tighten the bolts to 89 inch lbs. (10 Nm).
- Install the regulator to the door and install the mounting bolts. To ensure proper orientation of the window regulator to the door, it is very important that the window regulator bolts are tightened in the specified sequence. Tighten the bolts to 89 inch lbs. (10 Nm) in this sequence.
- Lower Right
- Upper Right
- Lower Left
- Upper Left
- Attach the electrical connector.
- Carefully untape the window and lower the glass far enough to gain access to the bolts through the door metal. Tighten the bolts to 89 inch lbs. (10 Nm).
- Install the plastic sheet water deflector.
- Install the door trim panel, as outlined in this section.
Thank You For Using Fixya.
Please give a good feedback, also let me know if you need any further Info.
Good luck.
Fixe_You ^^
×