C0035 meaning of engine code C0035

DTC C0035-C0051
Circuit Description
As the wheel spins, the wheel speed sensor produces an AC signal. The EBCM uses the frequency of the AC signal to calculate the wheel speed.

DTC C0244 or P1689
Circuit Description
Traction Control is simultaneously controlled by the EBCM and the PCM. The PCM sends a DELIVERED TORQUE message via a Pulse Width Modulated (PWM) signal to the EBCM confirming the delivered torque level for proper Traction Control system operation. The EBCM supplies the pull up voltage.

DTC C0550
DTC C0550 is set when an internal EBCM malfunction exists.

Yeah , I'd say they were all related - electronic brake control module- ABS

whats the whole code is it c0035 or p0035 https://www.autocodes.com/c0035_chevrolet.html http://p0035.enginetroublecode.com/chevrolet-touring https://www.troublecodes.net/pcodes/p0035

C0040
Right Front Wheel Speed Sensor Circuit Malfunction
EBCM
DTC C0035-C0051

The wheel speed sensor produces an alternating current signal whose amplitude and frequency vary, depending on the velocity of the wheel. The electronic brake control module (EBCM) uses the frequency of the AC signal to calculate the wheel speed.

This wouldn't have anything to do with not starting ! Won't start how ? When you turn the key to the start position what happens ? Does the starter engage an spin the engine ? This would be a crank no start , now if nothing happens when you turn the key this is a no crank - no start .

C0035 is ABS Sensor in left front wheel
C0040 is ABS Sensor in right front wheel
C0201 is ABS Enable Relay Contact Circuit
You most likely have a poor ground connection or a faulty EBCM (Electronic Brake Control Module) for these conditions. I recommend having someone run a diagnostic test at a shop. I doubt the ABS issue is stopping the truck from cranking.

need more info to enter into database, VIN would be best

wheel speed sensor code. check the wires on both front wheel bearings. Most likely cause is a broken wire.

Hi,
There is more to the code than C0035 there should be a 5A,18,0F,06. after the code to tell you what wheel is having the problem and what is wrong with it. You need a good scan tool for that, a code reader will only tell you part of the code.

Check that the sensor /wire was not damaged in the repair process. As the brake system is set up in a cross pattern left front and right rear and right front and left rear the code is reading the pair that is subject to failure. This crossing of the brakes is so if you have a brake failure and loss of fluid then half of the system is still operational and will allow stopping in a straight line rather than a side skid.

Sounds like you need front wheel speed sensors. Replace the wheel bearings and sensors. May have an ABS unit fault, but more likely is both wheel bearings/speed sensors.

This solution is for 1987 to 1989 Chevrolet Camaro vehicles, TPI V8s.

It's an Idle Air Control (IAC) circuit failure. The close throttle engine speed is 125 RPM above or below desired (commanded) idle speed for 45 seconds. See a dealer service department for trouble diagnosis.