How to fix check gage light - 1994 Plymouth Acclaim

First what had abnormal reading ? it is not the gage needing service

Fix the problem gage show (low gas,hot,voltage etc...low ,flasher on to long , coolant ,low brake fluid ...)parking brake on! Tcc , ABS,SRS light, check engine ,It tell you to see you gage check and fix the problem an check gage will come out

you need to have the wiring checked for short to ground then if the wiring is ok i would replace your fuel tank sending unit(fuel pump assembly)

check you speedo sencer maybe replace it this will fix your problem

Have either autozone or auto discount...depending on your location, they will check it for free an tell you what the problem is.. they can reset it..however it will continue to come on until the problem is resovled

Hi, Yes it could well be a ground problem or a bad relays. Look in fuse box for relays and/or replace.. Good luck.

CHECK GAGES light (1) indicates a potential engine failure(low oil pressure, low coolant, coolant overheating) has occurred.
· Check gages and shut down engine. Gages should read as follows: Oil pressure 5 to 10 psi (34 to 69 kPa) at idle; Water Temp gage below 230 degrees (110 C).
· Check engine oil level (Para 2-11) if OIL PRESS gage indicates low reading. Check coolant level (Para 2-11) if Water Temp gage indicates high reading. Notify Unit Maintenance if levels are low.

If CHECK ENGINE light (2) is on, check engine oil pressure gage (3) and water temperature gage (4). If both indicate normal, proceed with mission and then notify Unit Maintenance. If either one does not indicate normal, stop engine immediately and notify Unit Maintenance

you need to replace your sending unit first. its usually $5 or so dollars. If you still have the problem after you fix that. you may have a more serious problem.

Take it to Autozone . They do the free diagnostic and with it being a check guages issue it will pinpoint what the actual problem is so you know exactly what you need to fix. Good luck

probably just a warning system in the car to get your attention many cars that have an alternator or battery thats going bad the temp gauge will jump up to hot soon as the problem is fixed everything returns to mormal

A "check gage light" typically indicates a faulty reading on one of the gages located on your instrument cluster. After starting your vehicle, observe your instrument cluster if one of the indicator needles on the instrument cluster remains all the way to the left or "pegs" out all the way to the right, it may be the cause of your fault. The exception is the coolant temperature gage it will take 10 to 15 minutes after which the needle should rise to a normal position. Correcting the "faulty gage light" will depend on which gage is malfunctioning. Once you have figured out which gage is causing the check gage light to illuminate, then we can proceed to correcting the problem causing it.