CV Axle removal
SOURCE: trying to get the bearing off of the cv axle 1994 camry
I think you mean cv joint. If so, a new axle cost $59. You are doing alot of extra work and the joints could be damaged. The outer joint comes off, but it takes a large hammer. The inner joint usually has an inboard ring clip that you pop out with a screwdriver.
SOURCE: i need a diagram to show me how to replace cv axle
probably the easiest way is to go to your public library and look through their auto repair books and photocopy the page with the instructions/pictures for your particular job.
SOURCE: I M TRYING TO REMOVED THE DRIVER SIDE AXLE BOOT ON
I assume you have removed the axle from the wheel hub? and if you didn't and can't get it past the hub you will have to disconnect the lower ball joint by remove the bolt and tap on the tie rod end to remove the tie rod end then force the ball joint down to swing out the rotor Assembly and remove the axle nut and move it out of the way and take a flat bar and snap the shaft out of the transmission. And sometimes like the first guy said the snap ring could be damaged and it can be a bear to get out god luck, and if you drop the axle on the seal you will have to replace that too.
SOURCE: 1996 toy corolla cv axle removal
Use a pry bar and lever the axle out of the transmission.
It's easier if you have the outer end of the axle already removed from the hub.
To put the axle back in, use one quick shove and it will pop into place.
Frank
Frank's Friendly Cars Maui Car Rental
www.MauiCarRental.biz
SOURCE: need help removing right side cv axle on 94 toyota
Assuming you have the spindle off - you need a pry bar between the inner mount and the transaxle. Give it a bit of a snap as it is held in with a lock ring around the spline. Note the gap - when replacing it - pop it in fairly well till you feel the snap ring lock back into position. If you are replacing it - inspect the new one - the lock ring should already be installed.
162 views
Usually answered in minutes!
×