1994 jeep cherokee country has no spark - 1994 Jeep Grand Cherokee

SOURCE: 1994 jeep cherokee workshop manual free download required

onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/chrysler/1993-chrysler-zj-jeep-grand-cherokee-grand-wagoneer-service-manual-and-supplements-pdf.html
just go the above link i think u can get one online for free please rate my answer

ZJ Limited

• 17989 Answers
• Posted on Nov 05, 2009

SOURCE: how do i replace a starter in a 1994 Jeep cherokee

For removal & installation...

1. Disconnect the battery ground.
2. Raise and support the vehicle on jackstands.
3. On 1989-91 models equipped with a 2.5L engine, it is necessary to remove the exhaust clamp and bracket, and the transmission brace rod before removing the starter.

1. Remove all wires from the starter and tag them for installation.

1. On 4.0L, 5.2L and 5.9L engines, it may be necessary to remove the oil cooler line bracket and the exhaust brace.
2. Remove all but one attaching bolt, support the starter (it's heavier than it looks) and remove the last bolt.

1. Lower the starter from the engine.
2. If installing the original starter, inspect the pinion gear for damage or excessive wear.
3. Inspect the flywheel gear teeth for damage through the starter mounting hole.

1. Install the starter in the engine and hand-tighten the retaining bolts.
2. Engage any electrical connections that were removed from the starter.
3. Tighten the retaining bolts and engage any cooler lines, braces and brackets that were removed. Lower the vehicle.
4. Connect the negative battery cable and check for proper starter operation.

SOURCE: speakers for 1994 jeep grand cherokee

6.5" in all the doors dash is wierd. 2.75" but i have been able to squeez in a 3.5"

Testimonial: "thank you so much, that helps me out as lot"

SOURCE: My 1994 Jeep Cherokee Country's engine cuts out

Only good hands on testing will give you a valid answer to that question. I'd pay special attention to fuel pump pressure (measured at the rail), cam, crank and throttle position sensors (and possibly map sensor).
Those are the items that are most likely to cause a shut-down...Others will make it run poorly.
Many of the larger parts outlets do code testing free. Have that done and see what comes up. At this point a code for O2 sensor should be ignored as that can often trigger when another more important one is out of range.
As I said, without testing I'm only making an educated guess, but I hope something here helps you.
Good luck!

Testimonial: "Thank you so much! We tried to get it to an outlet code tester and they can't do it without an engine light being on, which it isn't. Good info!"

SOURCE: removing the wiper arms on a 1994 jeep cherokee sport

Pry up on the locking lever with small screwdriver, then pull the wiper arm off the pivot