SOURCE: jeep codes location of unit
Got me a complete manual for 199 jeep factory model and found location of each individual unit in question. Manual gives u possible solution to each code and repair and or replace. As a mechanic myself testing, trouble shooting and repair was not that difficult. Shift solenoid was very difficult to get to. Located under the head lamp passenger side.
SOURCE: HOW DO I GET TO THE BATTERY IN MY 1999 CONCORDE LXI
The batery is located in the right side finder. You have to pull the wheel and you will see the cover for it toward the front of the car behind the head lite. its not fun. Good luck
That is a code for an invalid skim key. If you have another skim key try it. If it does the same thing then the skim module may be bad.
SOURCE: Check Engine Light code on dodge caravan ec P1495
the leak detection pump pressurizes the evaporative system to check for leaks. the computer has detected there is a fault somewhere in the cicuit (wiring) that operates the pump.
SOURCE: 1999 Chrysler Sebring Convertible code P1495. I
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall,
just to the drivers side of the air-hat). You will have the solenoid
to check and the harness. What you want to measure is the voltage
coming from the harness and the resistance of the solenoid.
Turn the
key to the "ON" position but do not start the motor; the voltage at
the connector should be at least 10V or more,.now, check the
resistance of the solenoid (should be around 35 ohms).
Hope helps.
ECM fault-No CCD message from TCM
- Failed ECM
Probable Cause[s]
EVAP leak detection pump solenoid circuit condition
- ECM detected the pump solenoid did not change status when activated
Probable Cause[s]
438 views
Usually answered in minutes!
×