Ergo goft cart want go forward or backwards - 1993 Acura Vigor

This sounds like a drive motor issue, have that checked.

Hi
I would suggest you have the air cleaner replaced and clean out gas nozzle body.
Thanks
Roger

The right rear brake on my Granddaughters car was so worn that the pad jammed when turning backwards stopping any backwards motion. When going forward it did not jam and could be pushed or driven forward. Tell everyone that if you hear scraping noises when applying brakes to get them checked right away.

If the Cart sat for months, I would bet the ethanol gas gummed up your carb. Ethanol gas.... What are our politicians thinking????

A DC motor when run by an outside force becomes a generator. If you did not unhook the motor on your electric vehicle before you towed it you may have sent power backwards into the system. Things like computers and diodes and voltage regulators don't really like that. You may have a larger problem than before you towed it. Hopefully there is some sort of inline fuse. I'd check all the fuses with a meter before I gave it to a mechanic.

Probably. There may be a solenoid not working which is keeping the transmission from engaging the forward gear train but for it not to work at all is unusual.

It isn't wired wrong. Mine does the exact same thing, but it didn't used to be backwards and the wiring has never been changed.

Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

sounds like a contact in the selector is dirty or the selector it self is bad

hi,seat motor are in maximum length,try to seat,then apply force backward also the switch in backward mode.