Yes indeed. Alighnment caused that to happen. Your alighnment was not done properly or was incomplete. The company that alighned your vehicle is responsible.
SOURCE: Whenever my car hits the rough road its starts
have you checked the front struts. have a trusted technician inspect the front end.
SOURCE: Front End shakes when stepping on brakes at low
Did you also replace the calipers? Sometimes one of them will either have a pin hole leak or just not be as strong and the one on the opposite side. BUT that is normally accompanied by a pulling to one side or the other. Also if the rear brakes don't catch evenly it could cause a front end shimmee!
SOURCE: My 1990 toyota celica has a bad vibration in
Hi,
Have you ever replaced the shocks / struts? Are you sure your tire does'nt have a bump spot or out of round? I usually will swap the tires front to back to see if the vibration or bumping moves, good way to tell if the tire is bad. I've gotten some pretty poor tires before, some do have factory flaws that will cause that. Shocks will cause that also. Sway bar pins / joints that are worn can cause that also.
Mike
Testimonial: "brought to my attention a possibility i would have never thought to remember. thanks"
52 views
Usually answered in minutes!
×