Whats the procedure to remov e the tensioner
Ok you do not remove it ! You simple remove the tension from it. There is usually a nut or bolt on the front of it. Put a ratchet or breaker bar on that and go to the opposite direction from the belt. sometimes you will need three hands to remove the belt. Good luck! hope this helps.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jeff_24365d731679262d
Look for the 1/2" square hole on the tensioner. That hole is were you place a 1/2" breaker bar, to relieve the tension, by pulling on the bar.
SOURCE: How do I get the tension off the serpitine belt to remove
on the bottom there is a tension pully u can adjust it from there
SOURCE: do i have to remove the motor mount to loosen the
Yes,
to do so the engine will have to be supported.
Hope it will help
Dan
Fig. Fig. 16: Rotate the belt tensioner and...
Fig. Fig. 17: ... remove the belt from around one of the pulleys to remove the belt
WARNING
Use caution when removing or installing the belt and make sure the tool does not slip from the drive belt tensioner or personal injury or damage to the belt tensioner and the belt may occur.
74 views
Usually answered in minutes!
×