How to remove oil pan 1994 crown victoria

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

SOURCE: Trying to drop the oil

done this on several i-6 f-150s. slide back or remove transmission, remove motor mount bolts from frame(not motor), jack motor up as far as possible without damaging egr valve or wiper motor when they hit, shim under motor mounts so that when you drop the jack the motor does not come back down any(the motor is well balanced on the mounts, it will not fall out of the truck like a v8 will), then remove the oil pan. you May have to remove the pickup tube(usually not), and you May have to rotate the crankshaft so that the lobes clear the oil pan. this is a common problem with these trucks due to the size of the oil pan(Huge), and the minimum pan to crossmember clearance

SOURCE: The speedomter on my 1994 Crown Victoria has stopped working

most likely the speed cable broke.

Dave

SOURCE: 94 crown vic driver power window does not work can

The window regulator can be broke. Its made of plastic and they break often.

SOURCE: no oil pressure on my 03 crown victoria

KNOCKING NOISE IS NOT A GOOD SIGN.SOUND IF YOUR ENGINE OIL LEVEL IS CORRECT NOT LOW. SOUND LIKE OIL PUMP AND MAIN BEARING FAILURE.YOU NEED A REBUILT ENGINE OR OVER HAUL.