The air blower on my vitara will not stay on fresh air it keeps switching to recirculate and it flashes I've put a new cabin filter in but it hasn't made any difference please help
SOURCE: Cabin Air Filter
good news is it can be changed with no tools in about 2 minutes. just take out the glove box and the cover comes off easy.
SOURCE: cabin filter element location
Filter is located behind the glove box. All you need is a screwdriver to replace.
1. Open the glove box and empty to take the weight off the box.
2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.
3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.
4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.
5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.
6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.
7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.
SOURCE: where is a place cabin filter suzuki gran vitara
Drop the glove box lid. Empty it and press the sides inwards while 'forcing' it open beyond it's normal stopping point. There'll be a kinda large black box behind the opening. In the centre (or almost) of the box is a vertical cover which kinda looks like a grille. Remove it by releasing the clips at the top and bottom. you might have to feel around for the clips. They're not exactly in front of you, the top one is almost on top of the box and the bottom one is towards the underside of the box. When the cover comes off slide the filters (there are two (upper and lower) out and replace them, then replace the cover and push the glove box lid back into place.
SOURCE: suzuki vitara (1992) keeps running after turning it off
What you have is what is called pre ignition and that is caused through getting rather hot and to much fuel going into the engine and holding on the carbon which is on the piston tops (all cars have the carbon on the pistons) but you are getting to much called Running to rich and when you turn off then the petrol in the carbon and the heat keeps it firing BUT most times the engine will run backwards ( in reverse) so get it tuned and save your engine.
Have a goodday and let me know how you get on . Ron
SOURCE: Hi, I have a 2007 suzuki grand vitara and recently
Look first for the fuse of the blower unit in the main fuse box. replace, if this blows off again the blower fan is faulty.
However if the fuse is intact then you must check the blower switch on the dash for poor contact.
replace as required.
417 views
Usually answered in minutes!
×