What all do you have to remove to get to all the bolts on the pan
SOURCE: Remove oil pan from 2007 Saturn Hybrid Vue
Believe it or not, it is a VERY simple task. Take a flat-tipped screwdriver and tap in between the motor and oil pan. All automotive books say the SAME thing. This is regular practice and will NOT damage anything. You have to pry the pan off. If it is adhered this good....make double sure you clean both surfaces off before re-applying the new pan gasket. A scraper (has a razor blade on the end of a handle) will help the clean the block surface.
One thing to remember, once you get the gasket sealant oneither the block or the pan, let it set till it is tacky. Then, as you put the pan back up, work a cross pattern to install the bolts and only start them finger tight. Once you have all the bolts on, tighten then again in a criss cross pattern and try not to overtighten them until you have them all snugged down. Then tighten them to specs. DO NOT OVER TIGHTEN!!! You gasket will start to "seep" out and then you will have to repeat the process for a leaking oil pan.
If you need more info, post a comment again.
SOURCE: when replacing the oil pan on a 1997 saturn sedan
just hand shug is good on them not to crazy just hand tight
Testimonial: "thanks for the help"
SOURCE: 2002 Saturn SL2 crankshaft bolt removal
Look at rotation of harmonic balencer to remove bolt is in opposite direction.To remove bolt :Disconnect coil wire or wires so car will not start Next put socket on bolt with breaker bar and wedge bar some where solid on car. Bump motor with starter the small r turning of the starter will loosen bolt
SOURCE: In order to remove the oil pan from a 1997 Saturn
Hello, Counterclockwise to remove, clockwise to install. Hope thi helps
SOURCE: removing oil pan from saturn l300
the ac compressor bolts to the side of the pan and the trans bracket near the pass side of the trans
74 views
Usually answered in minutes!
×