The brake bulb is located in the tail light assembly. Pull the trunk liner back slightly and there should be 2-4 bolts holding the tail light assembly to the body. undo these and the whole thing should pull out.
SOURCE: Window dropped on driver side of my 2002 lincon ls.
Sounds like your window assembly has failed or the cable has broken. An easy repair, once the door panel is removed and the assembly disconnected from door.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_62314e5b2470e8b5
SOURCE: lINCOLN ls bRAKE lIGHT REPLACEMENT
One of 2 ways.......
#1) mounting screws on the exterior of the brake light lens.
#2) in the trunk behind the carpeting, usually this is the easiest way. either way the bulb is held in by a twist lock bulb holder.
GGBMDB
SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION
it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.
SOURCE: replace rear brake light bulb 1998 lincoln continental
pop the trunk and right behind where the lights are pull the carpet
down and their will be of the following depending on the trim.
You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.
If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk
SOURCE: How to change the fog light bulb on a lincoln ls
get under the car and the fog lamps will be on the corners of each side. all you do is twist the electrical connector to the right and it will come out to install one re connect the new bulb and line up the connector and turn to the left to lock it in place
of the LS. Position yourself on your knees in the back seat, facing the rear deck or rear dash.
light assembly, by hand. Pull the cover toward the front of the vehicle. Do not pull extremely hard, or you will break the clips that mount through the deck from the trunk.
out of the high-mount assembly. Wrap the new bulbs in a paper tower prior to picking them up. Insert new bulbs into the assembly, by hand. Do not touch the bulb lenses with your hands directly.
153 views
Usually answered in minutes!
×