Question about 1995 Hyundai Scoupe

1 Answer

Why l and r power mirrors wont adjust

Common faults

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 20,706 Answers

Blow fuse. ? test the fuses in the Fuse boxs.

Posted on May 05, 2014

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wing mirrors will not adjust


Wing mirrors have a certain range of electrical adjustment. Manual adjustment by pushing with fingers can make electrical adjustment inoperative. The solution is to make finger adjustment to get back to the electrical range.

May 22, 2016 | Cars & Trucks

1 Answer

Exterior / motorized / adjustable mirrors not working


Usually a bad switch would only fail in a couple positions..left to right both sides.if mirrors are completely inoperable I would look at a possible wiring concern, but I don't want to scare you, it could still be switch and they're comm

Apr 05, 2014 | 2002 Mercury Grand Marquis

1 Answer

I have a 2004 chevy 3500hd with power camper mirrors rhe passenger side mirror wont power out anymore driver side works fine can you replace the power out motor in the unit or not


I think you should go for manual first after that it would be easy for you to solve your problem. I had visited this site past 2 months before for my vehicle and find it quite helpful may be you will also get something useful here Best Manuals

Dec 18, 2017 | 2004 Chevrolet Silverado 3500

1 Answer

Memory seats adjust on there own as well as mirrors


BCM has nothing to do with this function , MMM - memory mirror module !
Memory Mirror System Operation
The MMM is capable of storing mirror position for 2 different drivers. Mirror position is determined by both horizontal and vertical position sensors in each of the power mirrors. The MMM supplies a reference voltage and a low reference to these sensors and determines mirror position through the horizontal and vertical position signal circuits.
The MMM receives power through the battery supply voltage circuit and the MIR/LOCK fuse and a constant ground source. Any time that battery voltage is disconnected and then connected from the MMM, the MMM will enter the mirror relearn mode. The mirror relearn mode can also be commanded using a scan tool. Refer to Memory Mirror Module Learn for further information.The memory switch receives power through the battery supply voltage circuit and the MIR/LOCK fuse. The MMM upon receipt of a memory switch signal input, a class 2 message from the SIC or a class 2 message from the PCM indicating that the transmission is in park, will then supply battery voltage and ground to the appropriate power mirror motors through the mirror motor control circuits to move the mirrors to the predetermined positions.

DTC B1586, B1596, B1616, or B1626
The mirror horizontal and vertical position sensors are potentiometers. The Memory Mirror Module (MMM) provides these sensors with a 5 volt reference circuit and a low reference circuit. The MMM monitors the horizontal and vertical position sensor signal circuits which change values based on mirror position. These voltage values are used to determine mirror position and can be set into memory. When the MMM receives a memory recall request, the MMM will control the power mirror to the memory position based on the horizontal and vertical position sensor signal values.

Install a scan tool.
Turn ON the ignition, with the engine OFF.
With the scan tool, observe the mirror horizontal and vertical position parameters in the Memory Mirror Module (MMM) data list.
Operate both the left and right mirrors through the full range of movements.
Does the scan tool indicate that the left and right mirror horizontal and vertical position parameters are within the specified range?

Memory Seat System Components
The memory seat system consists of the following components:
• Power seat switch assembly
• Memory recall switch assembly
• Horizontal adjuster motor
• Front vertical adjuster motor
• Rear vertical adjuster motor
• Recline adjuster motor
• Memory seat module
• Memory mirror module
• SEAT 25A circuit breaker
• MIR/LOCK 3A fuse

Your best bet , take it to a qualified repair shop !

May 23, 2017 | 2002 Cadillac Escalade

1 Answer

1999 gmc jimmy power windows locks mirrors wont work


If none of the mirrors or locks work, then you will very likely find a blown MIR/LCK Fuse #7 (10 Amp) in the underhood fuse block. If this is the case, you need to find out WHY the fuse blew because if you simply replace it, it will most likely do it again. Otherwise, the locks and mirrors also connect to the Body Control Module (BCM). I would recommend scanning the BCM for fault codes.

The windows are a completely separate circuit. They have nothing in common with the mirrors or locks other than than that they all ultimately get power from the battery and the circuits run through the umbilicals that go between the body and the doors.

If none of the windows are working, the most likely cause is an open power circuit or open ground circuit at the driver's door. This could be either a bad master control switch or is could be that the wires inside the umbilical are broken (fairly common).

Nov 04, 2011 | 1999 GMC Jimmy

1 Answer

2000 GMC Sierra Power mirrors do not work


sounds like a switch as common error oboth sides unlikely

Dec 31, 2009 | GMC Sierra 1500 Cars & Trucks

2 Answers

When I try to use the power mirrors the fuse blows.


A common problem with a short in the mirror circuit is the wiring that comes from the body to the door. When you open the door you will see a wire loom between the door hinges. If the fuse blows when attempting to adjust either mirror it would be on the drivers side. If the fuse blows only when adjusting the right mirror check the loom on the passenger side. From bending back and forth it is common that one or more of the wires in the loom have broken and possible shorted together. That would be the first place I would start to look to find this problem.

Nov 06, 2009 | 1994 Jeep Cherokee Country

1 Answer

Power mirrors, driver power seat, adjustable pedals all don't work... checked fuses and all ok... Any suggestions?


it sounds like the driver seat module. It controls all of these items.
buy used at car-part.com. look on page with * for lowest price.
buy new at discount at tascafordparts.com

  • The memory mirror is inoperative
  • Driver seat module (DSM).
  • Circuitry.
  • CJB fuse 3 (7.5A).
  • Exterior mirror motor.
  • Mirror control switch.


  • The memory seat is inoperative
  • Circuitry.
  • Seat control switch.
  • Seat track.
  • DSM.
  • PDJB Fuse 109 (30A).
  • Power seat motor.


  • Adjustable brake pedal does not operate correctly — does not operate using the adjustable pedal switch
  • Battery junction box (BJB) fuses:
    • 109 (30A).
  • Circuitry.
  • Switch.
  • Adjustable pedal motor.
  • Driver Seat Module (DSM

Oct 02, 2009 | 2003 Ford Expedition

1 Answer

Right Hand mirror doesn't retract


i would check the switch first and also the passenger side door jamb wire harness also i know it sounds simple but ALWAYS check ALL of you fuses before beginning any electrical fault tracing, try removing the switch and identify which wire powers the mirror and manually jump power with a paper clip to the mirror in question there should only be three wires one will have power and the others will be left and right mirror retraction if this works your switch is bad if not go to the mirror and power that manually and if no dice you got a bad motor -jeff

Jul 14, 2008 | 2001 Honda Civic

Not finding what you are looking for?
1995 Hyundai Scoupe Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...