Question about 1993 Acura Vigor

Open Question

Won't go forward or reverse - 1993 Acura Vigor

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 sts won,t crank


I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It wont move forward or
reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.comAll the best

Mar 21, 2018 | Cars & Trucks

1 Answer

Water got in door now power windows and mirrors and door locks won’t work but back 2windows work


I tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my
jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com

Feb 24, 2018 | Cars & Trucks

1 Answer

Gas 2007 Ezgo has new battery but won' crank. Clicks in forward and buzzes in reverse


Sounds like bad solenoid or starter, but you may get better answers by posting in the correct section. This is for cars and trucks.

May 28, 2016 | Cars & Trucks

1 Answer

96 ROVER DISC. Has strong reverse - won't engage any forward gears. Fluid seems full even when warm.


Make sure the 4wd shifter is in correct position and hasn't slipped out of correct spot to get you moving forward.

Mar 27, 2013 | 1995 Land Rover Discovery

1 Answer

Car won't reverse or go forward


you can try some fluid but changing it will just cost you money,fill it first,but if the old fluid is burnt the trans is prob toast

Dec 20, 2012 | Cars & Trucks

1 Answer

My rebuilt transmission won't go forward?


i would be checking the shifter cable adjustment first see how that goes goodluck

Sep 18, 2017 | 1992 Ford F250

1 Answer

My rebuilt transmission won't go forward?


its more than likely the valve block internal sticking valve or incorrectly rebuilt

Sep 07, 2017 | 1992 Ford F250

2 Answers

1999 FORD EXPERDITION TRANSMISSION WON'T MOVE FORWARD BUT MY REVERSE WORKS FINE WHAT I NEED TO DO


You can try shifting into manual 1 to get moving then once you get going shift the lever up into Drive. This should work, then drive it to a shop to have your ****** looked at.

Feb 08, 2012 | 1999 Ford Expedition

1 Answer

My 2000 dodge caravan won't reverse, how much would that cost, and what is wrong with it?


There are pressure ports on the side of the 4 speed under the solenoid pack. These are 1/16 pipe thread, with a gauge you could check each one.

From the engine towards the transfer gear cover they are:

Underdrive
Overdrive
Reverse
Lock Up Release
2nd & 4th
Low & Reverse

These ports are connected very close to the clutches, so a bad seal will show up as low pressure. in reverse, look for at least 145 psi in Reverse and the Low & Reverse ports at the same time.
If pressures are good here, you likely have a broken ring gear on the rear planet. This will fail and will still have forward gears as the ring is not used during forward movement.
Good luck, i hope this helps.

Jul 06, 2011 | Dodge Caravan Cars & Trucks

Not finding what you are looking for?
1993 Acura Vigor Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...