Radio code need the radio and clock code for silhouette 1999

if the radio is original
security code .speakers and all other functions work

could be faulty speakers
or an internal circuit board failure

pull the radio out have radio checked
if beyond repair
you could source a used one or fit a newer after market unit

NEED RADIO UNLOCK CODE TO RESTORE RADIO
IPC INOP. SOUNDS LIKE IP CLUSTER IT'S SELF, COMMON ISSUE

if its in the radio face you use the knobs on the radio..volume.. tuning ..station setting etc..its a trial and error type of thing..parts store can give an exact printout..

code 0449 evaporative emission control system vent valve solenoid circuit malfunction check your fuses as well as connections and power going to the solenoid see manual for location of valve

Inertia swich maybe?????? I hit a pot hole with my car and shut off just had to posh the inertia button in trunk.

1999 Audi A4 2.8 V6 engine.
Starter - removing and installing
Caution!
Disconnect the battery Ground strap before working on the electrical system.
Notes:
1. Before disconnecting the battery, determine the correct coding for the anti-theft radio.
2. Once the battery is reconnected, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc) as described in the Owners Manual.

please read your owners manual . that code is for anti theft radios the information is in there hope this helps

I found the buttons! When the light was shining on my console I was able to notice them. The Hr and Min were no longer obvious in normal light, but there are two small buttons below the Volume Control knob that adjust the clock.

you need a special tool to get the radio out. It has pins that spread out spring clips so the radio can pull out.

please rate as solved if this helps.

SECTION 413-00: Instrument Cluster and Panel Lighting — General Information 1999 Town Car Workshop Manual
REMOVAL AND INSTALLATION Bulb —Electric Clock
Special Tool(s) Radio Removing Tool
T87P-19061-A


Removal

1. Disconnect the battery ground cable.

1. Pull out the radio using Radio Removing Tool.

1. Remove the radio.
   1. Disconnect the electrical connectors.
   1. Disconnect the antenna cable.
   1. Remove the radio.

1. Remove the instrument cluster finish panel bolts.

1. Remove the instrument cluster finish panel bolts.

1. Pull out and position aside the instrument cluster finish panel.

1. Disconnect the electric clock electrical connector.

1. Remove the instrument cluster finish panel.
   1. Disconnect the headlight switch electrical connector.
   1. Disconnect the dimmer switch electrical connector.
   1. Remove the instrument cluster finish panel.

1. Remove the electric clock illumination bulb.

in frt of the center console bolted to the floor i think to get to it you have to pull the center console out the trim piece to the left of the console and the glove box comes out there are two screws on the trim piece that surrounds the radio and heat control pull out the clock and there is a screw to remove the clock stick a small screwdriver under it pull down and the clock should come out gently pul on the trim pull alittle harder at the top the clips grab a little harder there pull out the radio if you have a anti theft radio make sure you have a radio code if you dont have a code write down the serial # on the radio you can call a honda dealer they can run the # and give you the code use the preset buttons to enter the code once you pull out the radio you can see the air bag computer it has torx screws that hold it in the brackett raise the ctr console lid you should see a cover lift it up there are 2 screws the trim around the gear lever pops off pull up on the cup holder remove it th e trim the top of the console puls up the rest of the screws comes out pull out the ctr pocket the rest is self explain