- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Fixyahttps://www.fixya.com > ... > Daihatsu > Terios
Nov 14, 2019 - The tappet clearance for your Hyundai Atos 2007 would be: ... Valve clearance Warm: 0.2 mm intake, 0.25 mm exhaust. ... Valve clearance Cold: 0.1 mm intake, 0.17 mm ...
Question edited for clarity and spelling.
Question moved to model category.
Some ideas here, but the best way is to find a local auto electrician or an alarm installer, auto locksmith. Better to reprogram rather than disconnecting the battery.
Timing chains do not need changed until they break or get so loose that they jump a tooth on the chain. But if you have a timing belt instead of a timing chain, it does need to be changed before it breaks. Replace the timing belt every 60,000 miles. Severe engine damage will occur if you do not replace the timing belt every 60,000 miles.
the procedure of aligning all the timing marks before removing the belt will be the same . The necessity of not moving crank and cams without the belt being connected is still relevant. How ever there are some differences as to tensioning the belt and timing balance shafts . The biggest killer of rubber belts is oil so the oil seals (Cams shaft/ crank shaft should be also replaced and hydraulic tensioner if you have one). Idler pulleys do as much work as the belt so replacing them to replace the bearings is also a good move. . To come up to speed as to the differences a workshop manual for your vehicle is strongly recommended.
The spark plugs are high up on top of the engine. You will probably need to remove the air filter box to get access to them. I'm not sure if the box is bolted down or a 'pull off' type. They are covered by the plug shaped coil packs. These just pull out and push back in. The attached photo has them marked with a red circle.
The timing marks (dots) are on the sprockets.. Make sure you have these lined up perfectly (use a steel ruler) before dismantling anything! Then you will have No.1 piston at TDC (top dead centre) and the job will go smoothly... ok?
×