Diagram to replace serpentine belt for 2003 outlander

To let you know I found these links with a google search for (2006 honda accord v6 belt diagram)
2003-2007 Honda Accord Serpentine Belt Replacement (2003, 2004, 2005, 2006, 2007) - iFixit Repair Guide
Video on how to change belt. Near the end of video he shows diagram.
How to Replace the Serpentine Belt on a 2003-2007 Honda Accord 3.0L V6 Step-by-Step - YouTube

2003-2013 Honda Accord V6 Accessory/Serpentine Belt Replacement - YouTube

Robert, Serpentine belt diagram. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How To Install Replace Serpentine Belt Ford Taurus 3 0L V6 1AAuto com
2003 Ford Taurus V6 3 0L Serpentine Belt Diagrams serpentinebelthq com
2003 Ford Taurus Belt Diagram Am Having Problem Getting My

try this link as have many diagrams just need to search for your vehicle good luck
Serpentine Belt Diagrams

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

To get this off, there are two ways:

1. Loosen the alternator, and pull it back until the tension is released.

2. There will be between the various pully's (belt runs around) a tensioner. This is holds the belt tight. With a rachet and socket, pull (push) the tensioner until the belt has slack - pull one part of the belt off (any pully) and release the tensioner back to it's position. (It will go further than when the belt was on - this is normal.

When installing the new belt, if using the tensioner, the belt will need to be placed on the tensioner last - get the belt around all other pully's in it's correct configuration, then, pull back (push) tensioner *(while holding the belt tight with other hand, and ready to be pushed over tensioner) and slide belt into place over it.

Also note: a serpentine belt will only go on one way (grooved side down).

Please let me know if you need further assistance.

carsandcomps,

Guru, Premium Expert @ Fixya.com

if you just changed the alternator you should do the belt too,if you get your belt from Auto zone or NAPA the belt routing is on the back of the package

From the Dayco web site:

You need a service and repair manual for that vehicle, about 15 or 20 bucks at any parts store, and some librarys.

Hi Paul,

The routing diagram is under the hood.

• Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
• Get the belt around all the pulleys except the A/C compressor or Alternator.
• The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
• Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  
• Slowly release the tension.
  
• You're done

Mike