SOURCE: 1974 porsche 911 2.7L ignition trouble
Post your problem on pelicanparts.com in the 911 tech forum area, great help here.
Jim
SOURCE: HELP...1987 944 wont start afer replacing timing belt
Hi, You need to get your timing belt checked. Dont attempt to start the engine until your timing pullys are reset because if your cam is set wrong it WILL cause valve damage.If it is allready correctly set then i suggest you test the compresion in case damage was caused when belt was fitted. Hope all works out ok 4 you.All the best.Phil
SOURCE: 92 Porsche 968 will not start
check out your 2 sensors on the bell housing , at rear of the engine one is reference sensor the other is engine speed sensor , this will not allow injection or ignition if one is defect , change both , there the same , lots intermitent problems from these sensors
SOURCE: 1094 944 porsche cranks but wont fire. fuel pump
run a fused wire from the positive side of your fuel pump to your "on" side of your ignition switch bypassing the alarm kill switch and, allowing you to drive the car
SOURCE: 1991 Porsche 944. starts fine, runs, then stalls...repeats..
fuel pump and or filter is my first guess
46 views
Usually answered in minutes!
×