Sill bad.?
http://www.fixkick.com/power-index.html
SOURCE: four wheel drive will not work on 1995 geo tracker
You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.
SOURCE: 1992 geo tracker will not run
The ECM has a blown capacitor inside it for opening the injector you will most likly need to get it rebuilt, buy a new ,or used ECM had the same problem with my sidekick.
SOURCE: My 1995 Geo Tracker heater blower dont run,need to
Hello there the heater blower is located under the hood on the firewall on the passenger side you will see a round motor looking item there this is your motor and blower now if you have checked the fuses for this than make sure that the wires that this motor is connected to are all in good condition if so than yes replace the blower motor
ok best regards michael
Testimonial: "Thank you"
SOURCE: 95 Geo Tracker - Automatic. Starts ok, but when
It needs a fluid change,and filter,in the transmission,also,add a additive called LUBEGUARD from napa auto parts,when you ask for the additive,be sure to get the one for gm,this additive keeps the valve body slick,and moving,this is the problem,your filter,and ,or,the fluid is dirty,and causing hydraulic problems,and valves to stick in the valve body in the transmission.
SOURCE: 1995 4x4 geo tracker front wheel bearings
first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.
69 views
Usually answered in minutes!
×