Lower ball joint torque specs 1999 Tahoe - 1999 Chevrolet Tahoe

SOURCE: need to know the torque

for a 72 which is the same front end: upper-install new joint torque the bolts that hold it on the a-frame to 45 ft. lbs. then torque the ball stud as follows: 40-60 ft. lbs. plus additional torque to align cotter pin not to exceed 90 ft. lbs. never back off to align cotter pin. then install cotter pin.

Marvin

• 85242 Answers
• Posted on Nov 02, 2009

SOURCE: torque spec for lower ball joint on 2002 chevy

100 foot pounds

SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs

A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.

SOURCE: need the torque specs for

hope this helps...

Marvin

• 85242 Answers
• Posted on Sep 20, 2010

SOURCE: torque spec's upper ball joint for a 1994 chevy

60-65 foot pounds.