I replaced the oil sending unit since it quit running and have disconnected the battery to clear codes. The fuel pump was replaced first of month.
SOURCE: Can't find flasher for blinkers on a 92 Chrysler New Yorker.
If you have the Owners Manual for the car look up flasher and it will show you a diagram of the relays so that you know what you're looking for. I own a 1992 Chrysler New Yorker Fifth Avenue and the flasher relay is located right above your glove box on the passenger side. You have to unscrew the glovebox casing with a phillips screw driver. Once you have this unscrewed there are your fuses and two sets of relays. One relay set that you can see on the right side (this is not where the flasher relay is) and one that is up more in the dash and closer to the inside part of the car by the side of the air condition controls. This is where the flasher relay is located. You can slide the whole casing of relays up off of the metal hook that it is held on by, and then pull it down and out so that it is easier to work on. There should be two square relays and two circle relays. When holding the case of relays, the two square relays are on the left and the two circle relays are on the right, it will be the top right circle relay that is the flasher relay. This took me forever to find. I hope this helps all of you so that you don't have to rip your dash apart like I did.
SOURCE: 89 Chrsler New Yorker Lebaron won't start
possibly the fuel filter. Try taking of the battery cables and resetting the computer
SOURCE: location of fuel pump relay on a 1989 Chrysler new
Open hood and on left fender are there are 3 relays. The first one toward front of car is the ASD relay or fuel pump relay.
SOURCE: what r the trouble codes for a 91 chrysler new
11 Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking
12 Direct battery input to PCM was disconnected within the last 50 key-on cycles
13 No change in MAP from start to run
14 MAP sensor voltage too low
Hope this helps. God bless
Testimonial: "was very helpful. thank you so much. The help is greatly appreciated "
501 views
Usually answered in minutes!
×