2000 corvette headlights will not open - 2000 Chevrolet Corvette

C4 Corvette 1984-1987 CNC Machined Headlight Gears - Large/Small ' Corvette Mods

You have major wiring problems or bad switches. I would replace the headlight switch before testing for any thing else. if it's the switch you got lucky, if not, it will be a lot of wire testing.

Are you looking for a wiring diagram or a head light switch with a vacuum diaphragm to operate the light covers or to bring up your lights when you turn them on,like a corvette,if like a corvette,I had a 1971 corvette that didn't open and I used the vacuum parts on the light switch off of a 1968 Pontiac GTO,the light switch was the same as the corvette

Sounds like a open wire. You can always run one from the other side

If you need further help, I’m available over the phone at https://www.6ya.com/expert/edward_020b3320326d263d

the relay for reversing the moter might need replaced

Corvettes have a gear box on that motor. It has plastic gears in it. You probably have a gear stripped in that gear box, that lets the motor spin free. You can get repair parts to repair it, or replace the whole motor and gear box. Its an easy fix if your handy. Read all the instructions before you start.

check wire going to motor for proper voltage or open circuit

Turn your ignition on and your headlights. Turn the key off and then the headlights. They should stay open. Open the hood. Remove the rubber 'bump stop' located next to the headlamp on the side that has the bad bulb. Be careful to not change the location of the lock nut.
Now you have a big opening that will allow you to reach down to the rear of the directional signal and remove the socket and bulb by turning counter clockwise. Replace the bulb. I like to put some dielectric compound or at least some vaseline on the base wires of the new bulb.
Test. Reverse procedure for reassembly. Congratulations....... you just saved $70.00!!! Dave

sounds like you need to replace the relay for that headlight door, also make sure all the connectors are clean and tight, check for water intrusion

wd40