SOURCE: i have A 1998 FORD RANGER EXT. CAB W/ 6 CYL.- 4.0
Take the top off the master cyl and slowly very slow push in on the clutch and watch for any bubbles comming up.Replace the top and pump pressure and bleed at the master direct by using the lines for bleeders.
SOURCE: clutch will not engage.
You have to bleed the system again they can be a pain in the b@TT, also get a second person to operate the clutch and watch to see if the lever moves, if it does pull off the rubber and make sure you have the Y on the pivot ball inside the transmission. And if you don't get enough throw adjust the clutch rod on the clutch pedal by removing the pin and loosen the lock nut and make it longer by unscrewing the shaft. You want a half inch of free play at the top of the pedal the you want the clutch to catch about 3/4 of the way down. Also if you try to put it in gear does it grind the gears? Also did you put the clutch plate in backwards this is a common mistake even for a pro who gets interrupted by a phone call or a good-looking gal walking by, if ya need more suggestions let me know by posting to this comment.
Avid101
50 views
Usually answered in minutes!
×