SOURCE: 2004 Jeep Grand Cherokee - problem with power windows/locks
This seems to be the affects of a bad dinamo charging your battery . If you take a appart the dinamo you should fine a part called in mechanic terms "the bones" they look like 2 black magnets with a wire coming out of them . They are not expencive and you should not change your dinamo untill you try this first a car dinamo is very expencive .
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: Jeep Headlights not working. High beam works
had the same problem on my 92....check under the hood on the drivers side,towards the front,there is a "junction box" with all of the lighting wires connecting from the switches to the lights.My wires were all corroded inside,so I cleaned the ends and bought a new box from the local electronic supply store.The problem has not come back.
Cheers
SOURCE: replace a crankshaft position sensor on a 1996
1st I need to know what engine you have, 4.0L or 5.2L V8.
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
154 views
Usually answered in minutes!
×