SOURCE: 1993 lincoln towncar sunroof switch
I know this is an old blog but some people may still find it helpful. There are 4 wires in the roof window switch hooked up to 2 smaller harnesses that have 2 wires each.
Remove the switch and use only the metal contacts in the harnesses. One should use a light tester to confirm which one is the ground and live. this is how it turned out for my car.
One harness has a light blue wire with a black stripe, and a black wire. the blue one is live, the black one is ground.
The other harness has a red wire and a darker blue wire (silly ford) these are the motor connect and return wires.
You must hook up thhooked to (example, if the live wire was connected to blue motor wire and the ground wire was connected to red motor wire and it opened it, that would mean you would want to put the live wire to the red motor wire and the ground wire to the blue motor wire)
When doing these wire connections, it is advised that you have the ignition turned off. Once you make all the connections properly, you can turn on the ignition and if done correctly, the roof window will move. Once it is closed, remove the wires frome the harnesses and LEAVE THE ROOF WINDOW ALONE UNTIL YOU HAVE A NEW SWITCH.
e power (Live, light blue) wire to a motor wire. You must then run another wire from the other motor wire. To complete this circuit there is only one place that this last wire can go and it is to the ground. once this is connected the roof should either open more or close.
To reverse the operation of the roof, simply reverse the position of the live and ground wires in respect to which motor wires they are
SOURCE: I need to find the
my sunroof of my daewoo leganza has a way that you can let the sunroof go up so you can check where the problem is at like mine the problem I had is that there is a plastic seal around the whole sunroof that some of it came off so if you have this problem also to buy JB weld and mix them together to where this seal is at around the sunroof but if you buy JB weld the 4 minutes when you mix the two tubes together that you only have 4 minutes before it sets up where you want it to go so make sure you mix both tubes on top of car but on a piece of cardboard. The weld can be taken off with acetone and also you can use plastic tight gloves when useing the weld. This weld will make a seal as well so this helps for water to not come into car.
SOURCE: My heated seats stopped working in my 2007 Lincoln
check the sensor under the seat and the plugin if Thats not it then check the fuse
504 views
Usually answered in minutes!
×