SOURCE: 2001 Toyota Celica GTS Clutch
i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.
SOURCE: 2003 Toyota Celica GTs 6-speed transmission problem
Grinding going into third gear only may indicate a worn syncronizer ring. There are no adjustments on the shift cables, so I doubt highly that changing the cables will help you, since you are talking about 3rd gear only. Please note: This issue may be still under warranty, if your vehicle has less than 60,000 miles and is not 5 years old. Replacement of 6-speed internal parts is best left to a pro.
SOURCE: 1985 convertible celica fuse location
Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.
SOURCE: Where is the cigarette lighter fuse in a Toyota Celica?
There are 2 possible areas. 1 is the fuse box beside your left foot. 2 would be in the engine compatment on the right.
SOURCE: Toyota Celica gts 2000 blowing cold air when heater is on.
nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.
269 views
Usually answered in minutes!
×