SOURCE: Flashing dashboard airbag light in 2003 Toyota Avalon
try wiggling wires under the front seats ,if that dont work then take the builb out
SOURCE: 1991 Toyota Previa Dashboard lights
Yeah you can remove the hood and enginge but it's much harder that way! Just kidding the dash is notthat hard to get out one speedo cable and four screws witll get the speedo head out so you can change the bulbs, they are miniture bulbs to.
SOURCE: 1992 Toyota Previa van,Oil dripping onto exhaust manifold, replace head gasket? need a free manual!
The toyota previa uses a formed silicone gasket for the valve cover and the cover is held in place by metric shoulder bolts ( 10mm). The valve gasket leaks because you can't get enough preload on the bolts to re-seat the old gasket when it gets old and shrinks. The shoulder bolts only allow you to tighten the gasket enough to seat the shoulder on the bolt. If you continue to torque down the suspected bolts, you will snap the bolt off ( don't ask me how I know this ). You can either 1.)replace the old gasket with a new one or 2.) remove the existing bolts around the leak area and put in new metric bolts that do not have a shoulder. You may want to put in a small sleeve into the existing bolt hole but shorter than the thickness of the valve cover to account for the smaller diameter bolt. You can now torque down the bolt and get enough preload to seal the valve cover without removing the old gasket. Make sure you use a torque wrench ( in-lbs) or be very careful not to snap these small valve cover bolts.
SOURCE: How to replace dash light bulb of 1991 Toyota Previa Van
pop fuse cover, remove vent housing, remove speedo upper cover, remove 4 bolts holding speedo remove speedo, change bulb
SOURCE: location of fuse box 0n toyota
in center of dash right above heater there is a Lil button push up and it should pop off
95 views
Usually answered in minutes!
×